This custom cut adhesive film secures the rear panel assembly to the case of an iPhone 14 Plus model A2632, A2885, A2886, A2888, or A2887. $3.99 Only 8 left in stock Go check out Mike at Go Cell Phone Repair! 3. 1. Posted: Nov 22, 2017. Options. Looking on eBay, there are suppliers that are selling the glass lens replacement for the iPhone 8. The whole bracket looks like it's soldered into the frame, but the lens appears to be replaceable. Apple's out-of-warranty fees for the more repairable iPhone 14 and iPhone 14 Plus with back glass damage range from $169 to $199, compared to $499 to $549 for iPhone 14 Pro models. The iPhone 15 features a 6.1-inch (diagonal) flat glass screen, thin black bezels, a pill-shaped, black "dynamic island" at the top of the screen, matte back glass, and colored aluminum side rails. Volume controls and the ring/silent switch can be found on the left edge while the power button is situated on the right. First remove camera from inside. Then heat up the glass en try to poke it with a flat screwdriver. Then try getting all the glass parts out. You can reheat it sometimes (makes it easier). When all the glass is removed, use a cotton bud with some nail polish remover to remove all the glue from before. After that you just need to put in a new Step 27 Rear-Facing Cameras. Remove the two Y000 screws securing the rear camera connector cover bracket: One 1.4 mm screw. One 1.4 mm (nonferrous) screw. This screw tends to not be attracted to a magnetized screwdriver. Make sure to reinstall it in the correct place—a magnetized screw may interfere with the compass. You can identify the iPhone 6 Plus by one of the following model numbers etched into the back case: A1522; A1524; A1593; The iPhone 6 Plus (along with the 6) was the first iPhone to introduce a glass screen with curved edges. The back case was made entirely from aluminum, with curved edges rather than the flat design found in the iPhone 4 and 5. When iFixit announced its score for the iPhone 14 last year, it said it was looking mainly at the repair-friendly design of the device. Unlike its other devices, Apple included a rear glass panel Step 28 Remove the camera cover. Lift the camera cover from the edge opposite to the logic board, and remove it. To reinstall the camera cover, first insert the tabs on the edge closest to the logic board into their slots in the phone frame. Then hinge the cover closed. Add a comment. sqAA.